SPP PINE MOULDINGS

SPP PINE MOULDINGS offers New Zealand’s most comprehensive range of re-manufactured timber mouldings and jambs. Available in finger-jointed or clears, SPP PINE MOULDINGS cover a wide range of mouldings available in untreated, untreated primed, H3.1 treated, and H3.1 treated primed options to suit your individual requirements.
The following should serve as a guide to our standard mouldings range; however other profiles and products may be manufactured to order.

Storage

All SPP PINE MOULDINGS, both pre painted and natural/raw, untreated and H3.1 treated must be stored in a dry environment, protected from moisture, direct sunlight and excessive heat. In addition, mouldings, sarking and flooring profiles should be acclimatised to their surrounding environment for at least 48 hours prior to installation.

Fixing

Mouldings can be nailed, glued or installed using a combination of both nails and adhesives.
Nailing: For 10-12mm thick profiles fix using 40-50mm brads or panel pins. For 18-19mm profiles fix using 60mm brads or panel pins.
Adhesives: Mouldings can be glued using most commercial brands of adhesives.
All joints should be mitre cut and glued during installation. For best results we recommend mouldings are installed using a combination of nailing and gluing.

Finishing/Painting (interior)

Un-Painted Mouldings

  1. Fill nail holes and any indentations with an interior filler and lightly sand smooth
  2. Apply one coat of acrylic interior sealer or acrylic interior undercoat, allow to dry and sand smooth as required
  3. Apply 2-3 coats of premium water based enamel lightly sanding after the first coat if required

Pre-Painted Mouldings

  1. Fill nail holes and any indentations with an interior filler and lightly sand smooth
  2. Check the machine applied coating is smooth and even, lightly sand as required, and spot prime any bare areas
  3. Apply two coats of premium water based enamel, lightly sanding after the first coat if required

Note: Always follow the paint manufacturers instructions on the paint can
For painting and staining exterior products please refer to Southern Pine’s Weatherboard systems finishing and painting recommendations.

More Information

For more information about Southern Pine Products, our products, and recommended installation and finishing details please contact Southern Pine Products at:
Christchurch – 03 349 9175
Auckland – 09 573 0484

MOULDING PROFILES GALLERY